Movincool Classic 60 Spécifications télécharger pdf (Page 23)

INSTALLATION (cont.)

Optional Accessories and Set Up Configuration (cont.)

Outdoor Installation of the Unit (For Classic 40 and Classic 60)

The unit can be installed outdoors, sending the cool air indoor. More information

is available at WWW.MOVINCOOL.COM.

Note:

1. Make sure to run power and remote controller wires through conduit tubing.

2. Make sure to install a residual current operated circuit breaker in the power

supply.

3. Completely seal the through holes in the wall for conduit and duct to prevent

entry of rain. Use watertight fittings.

4. Do not place the unit directly on the ground. Install the unit at least 7 in. (178

mm) of clearance above ground. The optional standard stand kit (for Classic

40 ONLY) ensures a ground clearance of 7 in. (178 mm) or more.

DUCT SUSPENSION WIRE

SEAL HERE TO PREVENT

ENTRY OF RAIN

BUILDING

WALL

STAND

KIT

DUCT

POWER BOX

WALL THERMOSTAT

POWER WIRES RUNNING

THROUGH CONDUIT TUBING

WALL THERMOSTAT WIRES

RUNNING THROUGH

CONDUIT TUBING

7 in. (178 mm)

OR HIGHER

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 45 46

Pas de commentaire

Movincool Classic 60 Spécifications Page 23